原文由 redanqi 发表:
9.1 Chemical trap replacement procedure
:化学捕集的更换程序
应该是化学捕集器或者化学阱的更换程序吧?
• ***:Set the analyzer in manual injection mode and wait the end of cycle.
等一个周期结束后,在手动进样模式下设定分析仪。
时间顺序好像不对,在手动进样模式下设定分析仪,并等至周期结束。•
***:Remove the expired trap.*
移开需要更换的阱
移除跟移开的动作结果应该是不一样的。
• ***:Remove the caps (or plugs) from the new trap.
移开新阱的封帽或者堵上换下的阱的封帽
同样问题,另外,换下的阱的封帽是指旧阱吗?好像不是说旧的,还是新阱。
原文由 redanqi 发表:
Let the system stabilize and readjust the carrier flow. If the carrier pressure is different from the previous one for the same carrier flow, you will have to enter new timing parameter for the beginning and ending of a peak. Furthermore, venting ending time may require slight readjustment. This is caused by different pressure drop from one trap to the other.
待系统稳定后,重新调整载气流量。如果载气压力与以前的压力不同但流量相同,须为一个峰的开始和结束输入一个新的时间参数。此外,吹扫末期时间将需要做微调。这些都是由于从一个阱换成另一个阱产生不同的压力而造成的。